Agilent Technologies 4294A Operating Manual page 217

To customize:
Pen 2
(#2 of the graphic drawing pen set
Pen 3
(#3 of the graphic drawing pen set
Pen 4
(#4 of the graphic drawing pen set
Pen 5
(#5 of the graphic drawing pen set
Pen 6
(#6 of the graphic drawing pen set
1. Graphic drawing pens specified in an HP Instrument BASIC program or trace plotting
Step 6. Press the
Step 7. Press the
the currently applied hue as an integer between 0 and 100. This number is an index to a
particular point on a hue ring that defines color transitions from red to blue to black and
finally back to red. If the current hue is pure red, it is represented as zero.
Step 8. Use the keys or rotary knob of the ENTRY block in one of the following ways to specify
the hue as an integer between 0 and 100.
• Enter the desired value with the numeric keys (
• Turn the rotary knob (
• Press the step keys ([­][¯]) to set the desired value.
Step 9. Press the
screen indicates the currently applied brightness factor (%) relative to the maximum
brightness. (100% means the highest brightness.)
Step 10. Use the keys or rotary knob of the ENTRY block in one of the following ways to specify
the brightness factor (%) relative to the maximum brightness.
• Enter the desired value with the numeric keys (
• Turn the rotary knob (
• Press the step keys ([­][¯]) to set the desired value.
Step 11. Press the
indicates the currently applied saturation (whiteness) factor (%) relative to the pure color.
(0% means white, and 100% means pure color.)
NOTE If you set the saturation to 0%, the color becomes white and is not affected by any changes
to the hue.
Step 12. Use the keys or rotary knob of the ENTRY block in one of the following ways to specify
Chapter 7
Customizing Intensity and Color Settings for Screen Display
1
)
1
)
1
)
1
)
1
)
pens specified for each segment of a list sweep cycle
to display the Item Color menu.
MODIFY COLOR
key. The Parameter Setting field in the upper left area of the screen indicates
TINT
m m m m ) until the desired value is set.
key. The Parameter Setting field in the upper left area of the
BRIGHTNESS
m m m m ) until the desired value is set.
key. The Parameter Setting field in the upper left part of the screen
COLOR
Setting Up the Display of Measurement Results
Press:
-
more 1/3 PEN 2
- -
more 1/3 more 2/3 PEN 3
- -
more 1/3 more 2/3 PEN 4
- -
more 1/3 more 2/3 PEN 5
- -
more 1/3 more 2/3 PEN 6
to ) and then press the
[0] [9]
to ) and then press the
[0] [9]
key.
[´1]
key.
[´1]
209