Analysis and Processing of Result
Set a limit to the trace and make pass/fail evaluation
Conduct the limit line test
After completing the limit line table, conduct the limit line test according to the following
procedure.
Step 1. Press the
Step 2. Press the
Step 3. Press the
appear on the screen, and the result of the limit line test will be displayed for each sweep.
(PASS denotes acceptance, while FAIL indicates rejection.)
Softkey label
LIMIT TEST ON off
LIMIT TEST on OFF
Figure 8-26
Limit line test function ON (example of acceptance by test)
262
key to display the system menu.
[System]
key to display the Limit Test menu.
LIMIT TEST
key to turn execute the limit line test. The set limit line will
LIMIT TEST on OFF
Limit line test state
ON (execute)
OFF (don't execute)
Chapter 8