Agilent Technologies 4294A Operating Manual page 128

Setting Measurement Conditions
Sweeping Multiple Sweep Ranges with Different Conditions in a Single
Action (List Sweep)
The above setting will add a new value for the sweep stop or span frequency to the cell
located in the segment raw and the sweep stop/span frequency column (START or
CENTER) of the list sweep table in editing mode.
Step 8. Press
points for the segment in the parameter settings area located in the upper left of the screen.
Step 9. Use keys or the rotary knob of ENTRY block in one of the following way to specify a
value for the number of points.
•
•
•
The above setting will add a new value for the number of points to the cell located in the
segment row and the number of points column (NOP) of the list sweep table in editing
mode.
NOTE The number of points that can be set for a single segment is an integer ranging from 2 to
201. Up to 801 points can be set to any segment.
Step 10. Press the
Step 11. Press the
mode).
Softkey label
OSC MODE [VOLT]
OSC MODE [CURR]
The setting above will modify the unit, according to the selected mode, in the cell located
in the segment row and the oscillator level column (OSC) of the list sweep table in editing
mode.
Step 12. Press the
the segment in the parameter settings located in the upper left area of the screen.
Step 13. Use the keys or rotary knob of the ENTRY block in one of the following ways to specify a
value for the oscillator level.
•
•
•
The setting above will add a new value for the oscillator level to the cell located in the
segment row and the oscillator level column (OSC) of the list sweep table in editing mode.
Step 14. Press the
120
key. This will display the current setting for the number of
NUMBER OF POINTS
Enter the desired value with the numeric keys (
key.
[´1]
Turn the rotary knob ( m m m m ) until the desired value is set.
Press the step keys ([­][¯]) to set the desired value.
key to display the second page of the segment edit menu.
more 1/3
key to select a signal source mode (pressing the key toggles the
OSC MODE [ ]
key. This will display the current setting for the oscillator level for
OSC LEVEL
Enter the desired value with the numeric keys (
unit key ( , ,
[G/n] [M/m] [k/m]
Turn the rotary knob ( m m m m ) until the desired value is set.
Press the step keys ([­][¯]) to set the desired value.
key to display the dc bias mode menu.
BIAS MODE [ ]
to
[0] [9]
Selected signal source mode
Voltage source mode
Current source mode
to
[0] [9]
, or ).
[´1]
, and ) and then press the
[.]
, , and ) and then press the
[.] [-]
Chapter 5