Move The Limit Line In Vertical And Horizontal Directions On The Screen - Agilent Technologies 4294A Operating Manual

Analysis and Processing of Result
Set a limit to the trace and make pass/fail evaluation
•
Figure 8-28 Limit line table editing with limit line test function

Move the limit line in vertical and horizontal directions on the screen

You can set the offset of the sweep parameter value and that of the measurement parameter
value for the entire limit line set in the limit line table.
When the horizontal axis represents a sweep parameter axis and the vertical axis represents
a measurement parameter axis, these offsets allow the entire limit line to move in the
vertical and horizontal directions. For example, this function allows the limit line to be set
according to the characteristics of a particular sample to be used for other samples with
different characteristics or with different measurement parameter values.
Step 1. Press the
Step 2. Press the
Step 3. Press the
Step 4. Press the
for the limit line in the set parameter value field in the upper left area of the screen.
Step 5. Use the keys or rotary knob of the ENTRY block in one of the following ways to specify
the sweep parameter offset value.
•
•
•
264
In the even of a failure, the limit line test fail bit of the GP-IB status byte is set to "1."
For more information on the GP-IB status byte, refer to Programming Manual.
key to display the System menu.
[System]
key to display the Limit Test menu.
LIMIT TEST
LIMIT LINE OFFSET
SWP PARAM OFFSET
Enter the desired value with the numeric keys (
of the unit keys ( ,
[G/n] [M/m]
Turn the rotary knob ( ) until the desired value is set.
m m m m
Press the step keys ([­][¯]) to set the desired value.
key to display the Limit Line Offset menu.
key to display the current sweep parameter offset value
to
[0] [9]
, , or ).
[k/m] [´1]
, and ) and then press one
[-] [.]
Chapter 8