Setting Fixed Frequency (Cw Frequency) - Agilent Technologies 4294A Operating Manual

Setting Measurement Conditions

Setting Fixed Frequency (CW Frequency)

Setting Fixed Frequency (CW Frequency)
Follow the steps below to specify a fixed frequency for the signal source when the sweep
parameter is any item other than frequency (i.e., oscillator level or dc bias).
Step 1. Press the
[Source]
Step 2. Press the
FREQUENCY
the segment in the parameter settings area in the upper-left part of the screen.
Step 3. Use the keys or the rotary knob in the ENTRY block in one of the following ways to
specify a value for the fixed frequency.
• Enter the desired value with the numeric keys (
of the unit keys (
• Turn the rotary knob (
• Press the step keys ([­][¯]) to set the desired value.
104
key to display the signal source menu.
key. This will display the current setting for the fixed frequency for
, , , or
[G/n] [M/m] [k/m] [´1]
) until the desired value is set.
m m m m
to , , and ) and then press one
[0] [9] [.] [-]
).
Chapter 5