Search The Maximum/Minimum Peak - Agilent Technologies 4294A Operating Manual

Precision impedance analyzer
Hide thumbs Also See for 4294A:
Table of Contents

Advertisement

Analysis and Processing of Result

Search the maximum/minimum peak

Search the maximum/minimum peak
The peak search function enables the main marker to be moved to the maximum or
minimum point in automatic mode.
Step 1. Activate the trace to be searched.
Active Trace
Trace A
Trace B
Step 2. Press the
trace, the main marker appears at the position of the sweep center value on the trace.
Step 3. Press the
NOTE
If the peak is defined in advance by the
this specified peak will be searched when the
defined in advance, search will be done according to the definition of the peak at
initialization.)
When multiple peaks are present, the main marker will go to the peak where the
measurement parameter value is maximum if the peak polarity is defined as positive. The
main marker will go to the peak where the measurement parameter value is minimum if the
peak polarity is defined as negative.
For details on the peak definition, see the description "Define the Peak" on page 232.
Step 4. In the presence of multiple peaks, use the softkey of the target menu to move the main
marker to a peak as shown below.
Peak search type
Search the maximum peak (the same function
as that of Step 3)
Search the maximum peak out of the peaks
smaller than the measurement parameter of the
current main marker
Search peaks in the left direction (direction of
decreasing sweep parameter values) from the
current marker, and move the main marker to
the first detected peak
Search peaks in the right direction (direction of
increasing sweep parameter values) from the
current marker, and move the main marker to
the first detected peak
NOTE
After moving the main marker to each peak, you can use the
228
key to display the Search menu. If the main marker is not on the active
[Search]
to display the target menu.
PEAK
Key operation
[A]
[B]
key inside the target menu, only
PEAK DEF MENU
key is pressed. (If the peak is not
PEAK
Key operation
PEAK
NEXT PEAK
NEXT PEAK LEFT
NEXT PEAK RIGHT
SUB MKR
key in the same
Chapter 8

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents