Adapter Setting - Agilent Technologies 4294A Operating Manual

Adapter Setting

You must ensure that the adapter setting is properly set after you finish connecting
accessories to the four-terminal pair port of the Agilent 4294A and before you start
measurement. If required, change it to the correct adapter setting. The adapter setting
includes adapter selection and the data acquisition process, which is called adapter setup.
Table 4-2 lists the device connections and corresponding adapter settings.
Table 4-2 Device Connections and Adapter Settings
Device Connection
A. Connect a direct 16034E
connection type test fixture 16034G
to the four-terminal pair port 16034H
16044A
of the Agilent 4294A and
16047A
connect the device to the
16047C
fixture contacts.
16047D
16047E
16065A
16089A
16089B
16089C
16089D
16089E
16314A
B. Extend the four-terminal 16048G and test fixture
16048G and 16452A
pair port of the Agilent
4294A with a 1-meter-long
16334A
four-terminal pair
configuration and connect
the device.
16451B
C. Extend the four-terminal 16048H and test fixture
16048H and 16452A
pair port of the Agilent
4294A with a 2-meter-long
four-terminal pair
configuration and connect
the device.
D. Connect the 42942A 42942A and 16092A
directly to the four-terminal 42942A and 16093A
pair port of the Agilent 42942A and 16093B
4294A, connect a dedicated 42942A and 16191A
test fixture to the 7-mm port, 42942A and 16192A
and then connect the device 42942A and 16193A
to the fixture contacts. 42942A and 16454A
Chapter 4
Adapter
Accessory
Selection
No Adapter (
2
2
2
2
2
2
Four-terminal pair,
1 meter (
Four-terminal pair,
1 meter (
Four-terminal pair,
1 meter (
Four-terminal pair,
2 meters (
42942A Terminal
Adapter (
)
42942A
Preparation of Measurement Accessories
Adapter Setup (data measurement)
(Ö: required; blank: not required)
1
OPEN
Phase
)
NONE
Ö
)
4TP 1M
Ö
)
4TP 1M
Ö
)
4TP 1M
Ö
)
4TP 2M
Ö Ö
7mm
Adapter Setting
SHORT LOAD
Ö
Ö
Ö
Ö Ö
67