Agilent Technologies 4294A Operating Manual page 394

Key Definitions
Softkeys displayed by pressing the [Sweep] key
Table B-49 Segment edit (Edit Segment) menu (2/3)
Key operation: [Sweep] - EDIT LIST - EDIT - more 1/3
[Sweep] - EDIT LIST - ADD - more 1/3
Softkey
BIAS MODE [ ] ä
Displays Table B-51, "DC bias mode (DC Bias Mode) menu," on page 387. In
[ ] of the softkey label, the currently selected dc bias mode (voltage mode:
[VOLT] or current mode: [CURR]) is displayed.
DC BIAS VOLTAGE Sets the dc bias voltage of the segment.
DC BIAS CURRENT Sets the dc bias current of the segment.
more 2/3 Displays Table B-50, "Segment edit (Edit Segment) menu (3/3)," on page 386.
done Stores the edited list sweep segment and returns to Table B-47, "List sweep (List
Sweep) menu," on page 384.
cancel Cancels the editing of the list sweep segment and returns to Table B-47, "List
sweep (List Sweep) menu," on page 384.
Table B-50 Segment edit (Edit Segment) menu (3/3)
Key operation: [Sweep] - EDIT LIST - EDIT - more 1/3 - more 2/3
[Sweep] - EDIT LIST - ADD - more 1/3 - more 2/3
Softkey
BANDWIDTH [ ] ä Displays Table B-33, "Measurement bandwidth (Bandwidth) configuration
menu," on page 376. In [ ] of the softkey label, the currently selected
measurement bandwidth is displayed.
POINT AVG FACTOR Sets the point averaging factor for the segment (averaging count performed for
each measurement point). Specify an integer between 1 and 256.
MKR ® START
Enters the frequency at the current marker position to the sweep start value of the
segment.
MKR ® STOP Enters the frequency at the current marker position to the sweep stop value of the
segment.
MKR ® CENTER
Enters the frequency at the current marker position to the sweep center value of
the segment.
more 3/3 Displays Table B-48, "Segment edit (Edit Segment) menu (1/3)," on page 385.
done Stores the edited list sweep segment and returns to Table B-47, "List sweep (List
Sweep) menu," on page 384.
cancel Cancels the editing of the list sweep segment and returns to Table B-47, "List
sweep (List Sweep) menu," on page 384.
386
Function
Function
GPIB command
(N/A)
DCV <value>
DCI <value>
(N/A)
SDON
SQUI
GPIB command
(N/A)
PAVERFACT <value>
MKRSTAR
MKRSTOP
MKRCENT
(N/A)
SDON
SQUI
Appendix B