Agilent Technologies 4294A Operating Manual page 303
Precision impedance analyzer
Hide thumbs
Also See for 4294A:
- Programming manual (518 pages) ,
- Operation manual (10 pages) ,
- Configuration manual (8 pages)
Table of Contents
Advertisement
1. The printing color may differ from that on the screen owing to the limitations of the ink
NOTE
The background during printing is always set to white.
Step 4. Press the
value field in the upper left area of the screen.
Step 5. Use the keys or rotary knob of the ENTRY block in one of the following ways to specify
the resolution (DPI).
•
Enter the desired value with the numeric keys (
[´1]
•
Turn the rotary knob (
•
Press the step keys ([][¯]) to set the desired value.
NOTE
DPI can be set to an integer ranging from 75 through 600.
Printing cannot be carried out at a resolution higher than that of your printer.
Step 6. Press the
the top of the paper) is displayed in inches in the set parameter value field in the upper left
area of the screen.
Step 7. Use the keys or rotary knob of the ENTRY block in one of the following ways to specify
the top margin (in inches).
•
Enter the desired value with the numeric keys (
key
•
Turn the rotary knob (
•
Press the step keys ([][¯]) to set the desired value.
NOTE
The top margin can be set in a range from 0 to 5 inches.
Step 8. Press the
the left side of the paper) is displayed in inches in the set parameter value field in the upper
left area of the screen.
Step 9. Use the keys or rotary knob of the ENTRY block in one of the following ways to specify
the left margin (in inches).
•
Enter the desired value with the numeric keys (
key
•
Turn the rotary knob (
•
Press the step keys ([][¯]) to set the desired value.
NOTE
The left margin can be set in a range from 0 to 5 inches.
Chapter 8
Print the measurement results and internal data with a printer
of your printer. For the setup procedures for color on the screen, see "Customizing
Intensity and Color Settings for Screen Display" on page 207.
key to display the current print resolution (dots per inch) in the set parameter
DPI
.
m m m m
) until the desired value is set.
key. Then the current top margin (the length of the blank area on
TOP MARGIN
.
[´1]
) until the desired value is set.
m m m m
key. Then the current left margin (the width of the white space on
LFT MARGIN
.
[´1]
m m m m
) until the desired value is set.
Analysis and Processing of Result
to
) and then press the unit key
[0]
[9]
to
and
) and then press the unit
[0]
[9]
[.]
to
and
) and then press the unit
[0]
[9]
[.]
295
- Quick Links:
- Learning Operation Basics
Hide quick links:
Advertisement
Table of Contents
