(pressing the key toggles your selection).
Softkey label
LIST SPAN [SINGLE]
LIST SPAN [SEGMENT]
NOTE
The setting in this procedure does not take effect when COMPLEX Z-Y is selected for the
measurement parameter because no axis for the sweep parameter exists in the graticule of
display.
Figure 5-20
Chapter 5
Sweeping Multiple Sweep Ranges with Different Conditions in a Single
Setting Measurement Conditions
Action (List Sweep)
Selected list span mode
Single span (linear-scaled frequency is used for
the horizontal axis, with the left end specified
as the minimum frequency in the list sweep
table and the right end as the maximum).
Segment span (measurement numbers are used
for the horizontal axis; the points indicate the
order of measurement points in the table and
are equally spaced along the full length of the
axis.)
125