Selecting Sweep Direction - Agilent Technologies 4294A Operating Manual

Selecting Sweep Direction

DUT can be measured in the desired sweep direction when its characteristics has hysteresis
with the sweep parameter.
Step 1. Press the
Step 2. Press the
the direction).
Softkey label
DIRECTION [UP]
DIRECTION [DOWN]
NOTE Setting the sweep direction is applied commonly to traces A and B.
Chapter 5
key to display the sweep menu.
[Sweep]
key to select the desired sweep direction (pressing the key toggles
DIRECTION [ ]
Setting Measurement Conditions
Selecting Sweep Direction
Selected sweep direction
Upward (from sweep start value to sweep stop
value)
Downward (from sweep stop value to sweep
start value)
99