Setting/Checking The Gateway Address - Agilent Technologies 4294A Operating Manual

• Turn the rotary knob (
• Press the step keys ([­][¯]) to set the desired value.
The 3rd part of the IP address can be set to an integer ranging from 0 through 255.
Step 9. Press the
4th part of the IP address (current set value) is displayed. Below it, the entire currently set
IP address is displayed in a smaller size.
Step 10. Use the keys or rotary knob of the ENTRY block in one of the following ways to specify
the 4th part of the IP address.
• Enter the desired value with the numeric keys (
key.
• Turn the rotary knob (
• Press the step keys ([­][¯]) to set the desired value.
The 4th part of the IP address can be set to an integer ranging from 0 through 255.
Step 11. Press the
4294A and to return to the Local menu.
NOTE When you want to cancel the setting of the IP address, press the
done
Step 12. Reboot the Agilent 4294A. This will put the entered IP address into effect.
When you set the LAN addresses (IP address, gateway address, and subnet mask) at one
time, you need to reboot only after the completion of all settings to put all of the LAN
addresses into effect.

Setting/Checking the Gateway Address

Follow these steps to set or check the gateway address. The gateway address is delimited
into four parts by periods; each part is independently set.
Step 1. Press the
Step 2. Press the
Step 3. Press the
part of the gateway address (current set value) is displayed. Below it, the entire currently
set gateway address is displayed in a smaller size.
Step 4. Use the keys or rotary knob of the ENTRY block in one of the following ways to specify
the 1st part of the gateway address.
• Enter the desired value with the numeric keys (
key.
• Turn the rotary knob (
• Press the step keys ([­][¯]) to set the desired value.
The 1st part of the gateway address can be set to an integer ranging from 0 through 255.
Chapter 9
m m m m ) until the desired value is set.
key. In the set parameter value field in the upper left area of the screen, the
4th
m m m m ) until the desired value is set.
key to store the IP address data set in Steps 3 through 10 in the Agilent
done
key. The previous IP address setting remains without changes.
key to display the Local menu.
[Local]
key to display the Gateway Address Setting menu.
GATEWAY ADDRESS
key. In the set parameter value field in the upper left area of the screen, the 1st
1st
m m m m ) until the desired value is set.
Setting/Using Control and Management Functions
Setting/Checking the LAN
to ) and then press the
[0] [9]
cancel
to ) and then press the
[0] [9]
unit
[´1]
key instead of the
unit
[´1]
315