Setting/Checking The Lan; Setting/Checking The Ip Address - Agilent Technologies 4294A Operating Manual

Setting/Using Control and Management Functions

Setting/Checking the LAN

Setting/Checking the LAN
This section describes how to set or check the addresses necessary to use the Agilent
4294A's LAN (Local Area Network) functions. For more information on the use of the
LAN, refer to the Programming Manual.

Setting/Checking the IP Address

Follow these steps to set or check the IP (Internet Protocol) address. The IP address is
delimited into four parts by periods; each part is independently set.
Step 1. Press the
[Local]
Step 2. Press the
IP ADDRESS
Step 3. Press the key. In the set parameter value field in the upper left area of the screen, the 1st
1st
part of the IP address (current set value) is displayed. Below it, the entire currently set IP
address is displayed in a smaller size.
Step 4. Use the keys or rotary knob of the ENTRY block in one of the following ways to specify
the 1st part of the IP address.
• Enter the desired value with the numeric keys (
key.
• Turn the rotary knob (
• Press the step keys ([­][¯]) to set the desired value.
The 1st part of the IP address can be set to an integer ranging from 0 through 255.
Step 5. Press the key. In the set parameter value field in the upper left area of the screen, the
2nd
2nd part of the IP address (current set value) is displayed. Below it, the entire currently set
IP address is displayed in a smaller size.
Step 6. Use the keys or rotary knob of the ENTRY block in one of the following ways to specify
the 2nd part of the IP address.
• Enter the desired value with the numeric keys (
key.
• Turn the rotary knob (
• Press the step keys ([­][¯]) to set the desired value.
The 2nd part of the IP address can be set to an integer ranging from 0 through 255.
Step 7. Press the key. In the set parameter value field in the upper left area of the screen, the
3rd
3rd part of the IP address (current set value) is displayed. Below it, the entire currently set
IP address is displayed in a smaller size.
Step 8. Use the keys or rotary knob of the ENTRY block in one of the following ways to specify
the 3rd part of the IP address.
• Enter the desired value with the numeric keys (
key.
314
key to display the Local menu.
key to display the IP Address Setting menu.
m m m m ) until the desired value is set.
m m m m ) until the desired value is set.
to ) and then press the
[0] [9]
to ) and then press the
[0] [9]
to ) and then press the
[0] [9]
unit
[´1]
unit
[´1]
unit
[´1]
Chapter 9