Selecting Linear, Log, Or List Sweep - Agilent Technologies 4294A Operating Manual

Selecting Linear, Log, or List Sweep

Step 1. Press the
Step 2. Press the
Step 3. Press one of the following keys to select the sweep type.
Sweep type
Linear sweep
Log (logarithm) sweep
List sweep
NOTE If the oscillator level or the dc bias is selected as the sweep parameter, you cannot select the
log sweep. For how to select the sweep parameter, refer to Appendix , "Selecting Sweep
Parameter," on page 84.
List sweep cannot be selected unless a list sweep table is prepared. Refer to "Sweeping
Multiple Sweep Ranges with Different Conditions in a Single Action (List Sweep)" on
page 116 to create the list sweep table.
The sweep type that is currently selected appears in the key label
Softkey label
TYPE [FREQ]
TYPE [LOG]
TYPE [LIST]
NOTE
The sweep type can be set to trace A and trace B in common. It is not necessary to select an
active trace or to verify the current selection before setting the sweep type.
Chapter 5
key to display the sweep menu.
[Sweep]
key to display the sweep type menu.
TYPE [ ]
Setting Measurement Conditions
Selecting Linear, Log, or List Sweep
Key stroke
LINEAR
LOG
LIST
of the
[ ] TYPE [ ]
Selected sweep parameter
Linear sweep
Log sweep
List sweep
key.
87