Agilent Technologies 4284A Operation Manual

1. UNKNOWN (MEASUREMENT) TERMINALS
Do NOT NOT apply DC voltage or current to the UNKNOWN terminals. Doing so will damage
NOT NOT
the 4284A. Before you measure a capacitor, be sure the capacitor is fully discharged.
2. MEMORY CARD
Use Agilent Technologies-specified memory cards containing 4284A-specific data only. If
other memory cards are used, the 4284A may be damaged. Non 4284A-specific data
contained on a memory card is not guaranteed, and data may be lost.
To insert a memory card into the MEMORY
facing upward and with the contacts at the slot opening･ Insert the card into the slot until
it "clicks" in place.
To remove a memory card from the 4284A, press the UNLOCK button and remove the
card.
Do NOT remove a memory card while LOADing or STORing data. Doing so may damage
the memory card and any data stored in the memory card may be lost.
Store memory cards in their furnished card cases when not in use. The card case protects
memory cards from contamination and electrostatic discharge.
Also, store memory cards under the following environmental conditions.
Storage Temperature Range: -30 ℃ to +70 ℃
Storage Humidity Range: 30%. to 85%. (@ +50 ℃)
Do NOT shock or stress memory cards.
When storing or moving your 4284A, be sure the memory card slot is empty (no memory
card inserted).
Do NOT touch the connector contact surface of a memory card and do NOT use chemical
liquids to clean the contacts.
CAUTIONS ON OPERATION
MEMORY card slot, hold the memory card with the label
MEMORY MEMORY