Automatically Performing Search For Each Sweep (Search Tracking) - Agilent Technologies 4294A Operating Manual

Automatically performing search for each sweep (search tracking)

Automatically performing search for each sweep (search
tracking)
In the preset setting, the maximum value/minimum value search, target value search, or
peak search function is executed only once when the corresponding key (MAX key, MIN
key, and so on) is pressed. On the other hand, you can set the search on the trace to perform
automatically at the completion of each sweep (search tracking function).
Step 1. Activate the trace for which you want to execute search tracking (to which the setting is
applied).
Active Trace
Trace A
Trace B
Step 2. Press the key to display the Search menu.
[Search]
Step 3. Press the
SEARCH TRK
key toggles your selection).
Softkey label
SEARCH TRK ON off
SEARCH TRK on OFF
Step 4. Select the search function you want to perform in the search tracking.
Search function
Maximum value search
Minimum value search
Target value search
Peak search
For details about each search function, refer to:
• "Search the maximum/minimum measurements" on page 223
• "Search the point of target measurement" on page 225
• "Search the maximum/minimum peak" on page 228 and "Define the Peak" on page
232
Chapter 8
Analysis and Processing of Result
Key operation
[A]
[B]
on key to turn on the search tracking function (pressing the
OFF
Search tracking function
On (search is executed when you press a
search execution key; it is also executed
automatically each time a single sweep is
completed)
Off (search is executed only when you press a
search execution key)
Key operation
MAX
MIN
TARGET
PEAK
235