Agilent Technologies 4294A Operating Manual page 261

value field in the upper left area of the screen.
Step 10. Use the keys or rotary knob of the ENTRY block in one of the following ways to specify
the parameter value.
• Enter the desired value with the numeric keys (
of the unit keys (
• Turn the rotary knob (
• Press the step keys ([­][¯]) to set the desired value.
Step 11. Repeat Steps 9 and 10 to set all required equivalent circuit parameters.
Step 12. Press the
Step 13. Regardless of the on/off state of the equivalent circuit diagram display function, the
measurement trace is displayed on the screen. The frequency characteristics of the
equivalent circuit having the set equivalent circuit parameter are simulated and displayed
on the screen.
Figure 8-21 Simulation of equivalent circuit frequency characteristics (performed after the
calculation in Figure 8-20)
NOTE
The result of simulating frequency characteristics is automatically stored in the memory
trace. At the same time, the
(display of both measurement data and memory storage) are selected. For the Trace
Definition menu, see the description of "Trace-based Comparison and Calculation" on
page 179.
Display of the equivalent circuit parameter on the measurement trace screen can be turned
on or off by the
Chapter 8
Calculate the equivalent circuit parameter and simulate the frequency
, ,
[G/n] [M/m] [k/m]
) until the desired value is set.
m m m m
key to simulate frequency characteristics.
SIMULATE F-CHRST
DATA and MEMORY
PARAMETERS ON off
Analysis and Processing of Result
to , and
[0] [9] [-] [.]
, or ).
[´1]
keys in the Trace Definition menu
key (
PARAMETERS on OFF
characteristics
) and then press one
key).
253