Agilent Technologies 4294A Operating Manual page 375

Table B-15 Trace definition (Define Trace) menu
Key operation: [Display] - DEF TRACE[ ]
Softkey
DATA For the current active trace (A or B), stores the measured data into the data trace
|
without further calculation and displays it
MEMORY
For the current active trace (A or B), displays the memory trace on the screen
|
Before selecting this key, you must store data into the memory trace.
DATA and MEMORY For the current active trace (A or B), stores the measured data into the data trace
|
and displays both the data trace and the memory trace
you must store data into the memory trace.
DATA–MEM For the current active trace (A or B), subtracts the data in the memory trace from
| the measured data, stores the result into the data trace, and displays it on the
screen
in the same color as the trace.
DELTA % For the current active trace (A or B), executes the calculation of
| {(DATA–MEM)/MEM}´100[%] (DATA: measured data, MEM: memory trace
data), stores the result into the data trace, and displays it on the screen
DELTA % is selected, "D%M" is displayed at the left edge of the screen in the
same color as the trace. You can select this key only when the measurement
parameter is not COMPLEX Z-Y.
DATA/MEM For the current active trace (A or B), divides the measured data by the memory
trace data, stores the result into the data trace, and displays it on the screen
DATA/MEM is selected, "D/M" is displayed at the left edge of the screen in the
same color as the trace. You can select this key only when the measurement
parameter is COMPLEX Z-Y.
DATA ® MEMORY For both trace A and trace B, stores the current measured data into the memory
trace.
return Returns to the display menu (1).
1. The factory default colors used to display traces of the state are as follows: data trace A, yellow; data trace B, blue; memory trace
A, green; memory trace B, brown. You can change the colors of the traces by using the keys in Table B-23, "Item color modifica-
tion (Color Item) menu (1/3)," on page 370.
Table B-16 Bias Monitor (Bias Monitor) menu
Key operation: [Display] - BIAS MON [ ]
Softkey
OFF Turns off the dc bias monitor display.
|
VOLT Monitors the dc bias voltage value and displays it in the lower right area of the
| screen.
CURRENT Monitors the dc bias current value and displays it in the lower right area of the
screen.
return Returns to Table B-13, "Display (Display) menu (1/2)," on page 366.
Appendix B
Softkeys displayed by pressing the [Display] key
Function
1
1
. If this key is selected, "D-M" is displayed at the left edge of the screen
Function
.
1
.
1
. Before selecting this key,
1
. If
1
. If
Key Definitions
GPIB command
DISP DATA
DISP MEMO
DISP DATM
DISP DMNM
DISP DELP
DISP DDVM
DATMEM
(N/A)
GPIB command
BMON OFF
BMON VOLT
BMON CURR
(N/A)
367