Softkeys Displayed By Pressing The [Local] Key - Agilent Technologies 4294A Operating Manual

Softkeys displayed by pressing the
Table B-94 Local (Local) menu
Key operation: [Local]
Softkey
SYSTEM Sets this instrument as the system controller when it is used in a GPIB system.
CONTROLLER This mode can only be selected by manual operation with the SYSTEM
| CONTROLLER key. Only one system controller can exist on each GPIB system.
Therefore, if there is already a system controller, you cannot set this instrument
as the system controller ("CAUTION: CAN'T CHANGE - ANOTHOR
CONTROLLER ON BUS" is displayed).
ADDRESSABLE ONLY Sets this instrument in the addressable-only mode, in which an address can be
set, when it is used in a GPIB system. You select this mode when there is already
a system controller in the GPIB system. Also, when the controller passes the
authority for GPIB control to this instrument, this mode must be set.
ADDRESS: HP-IB Sets the GPIB address used to control this instrument from an external controller.
ADDRESS: Sets the address of this instrument as a controller. This address is used when a
CONTROLLER controller passes the authority for GPIB control to this instrument.
IP ADDRESS ä Displays Table B-95, "LAN address (LAN Address) menu," on page 415.
GATEWAY ADDRESS Displays Table B-95, "LAN address (LAN Address) menu," on page 415.
ä
SUBNET MASK ä
Displays Table B-95, "LAN address (LAN Address) menu," on page 415.
Table B-95 LAN address (LAN Address) menu
Key operation: [Local] - IP ADDRESS
[Local] - GATEWAY ADDRESS
[Local] - SUBNET MASK
Softkey
1st Sets the 1st part of an IP address, gateway address, or subnet mask separated by
periods (.).
2nd Sets the 2nd part of an IP address, gateway address, or subnet mask separated by
periods (.).
3rd Sets the 3rd part of an IP address, gateway address, or subnet mask separated by
periods (.).
4th Sets the 4th part of an IP address, gateway address, or subnet mask separated by
periods (.).
done Stores the configuration of the IP address, gateway address, or subnet mask
specified with the above keys and returns to Table B-94, "Local (Local) menu,"
on page 415. After performing the configuration, turn the Agilent 4294A off and
then on again so that the configuration takes effect.
Appendix B

Softkeys displayed by pressing the [Local] key

[Local]
Function
Function
Key Definitions
key
GPIB command
(N/A)
(N/A)
(N/A)
ADDRCONT <value>
See Table B-95
See Table B-96
See Table B-97
GPIB command
(Refer to corresponding
higher-level keys in
Table B-94, "Local
(Local) menu," on page
415.)
(N/A)
415