Selecting Sweep Parameter - Agilent Technologies 4294A Operating Manual

Setting Measurement Conditions

Selecting Sweep Parameter

Selecting Sweep Parameter
Step 1. Press the
Step 2. Press the
Step 3. Select the desired sweep parameter
Sweep parameter
Frequency
Oscillator level (voltage or current)
dc bias
NOTE When selecting the oscillator level as a sweep parameter, follow the steps shown in
"Selecting Unit for Oscillator Level (Voltage or Current)" on page 106 to select sweeping
by voltage or current level.
When selecting the dc bias as a sweep parameter, proceed to the setting shown in "Setting
and Applying dc Bias" on page 107.
The sweep parameter that is currently selected appears in the key label
PARAMETER [ ]
Softkey label
PARAMETER [FREQ]
PARAMETER [OLEV]
PARAMETER [DCB]
NOTE See "Using Time as Sweep Parameter (Zero Span Sweep)" on page 94 for the
measurement with time as a sweep parameter (zero span measurement).
The sweep parameter can be set to trace A and trace B in common. It is not necessary to
select an active trace or to verify the current selection before setting the parameter.
84
key.
[Sweep]
key.
PARAMETER [ ]
key.
Key stroke
FREQ
OSC LEVEL
DC BIAS
[ ]
Selected sweep parameter
Frequency
Oscillator level (voltage or current)
dc bias
of the
Chapter 5