Setting With Sweep Time Delay - Agilent Technologies 4294A Operating Manual

Setting with sweep time delay

Time delay can be set at the point before sweep starts.
Step 1. Press the key to display the sweep menu.
[Sweep]
Step 2. Press the key to display the sweep time menu.
TIME
Step 3. Press the
SWEEP DELAY
delay in the parameter settings area in the upper-left part of the screen.
Step 4. Use the keys or the rotary knob in the ENTRY block in one of the following ways to
specify a value for the sweep time delay.
• Enter the desired value with the numeric keys (
of the unit keys (
• Turn the rotary knob (
• Press the step keys ([­][¯]) to set the desired value.
Chapter 5
Setting Time Delay for Measurement
key. This will display the current setting for the sweep time
, , , or ).
[G/n] [M/m] [k/m] [´1]
) until the desired value is set.
m m m m
Setting Measurement Conditions
to , , and ) and then press one
[0] [9] [.] [-]
103