When The Sweep Type Is List Sweep - Agilent Technologies 4294A Operating Manual

When the sweep type is list sweep:

Step 1. Activate the trace in which you want to specify a partial search range.
Active Trace
Trace A
Trace B
Step 2. Press the
Step 3. Press the
Step 4. Specify the partial search range by the following key operations:
Specify the partial search range
Full range of list sweep table
One specific segment of list sweep table
(specify the segment by the following steps)
Step 5. Press the
segment in the previous step. The set number of the current partial search segment number
is displayed in the set parameter value field in the upper left area of the screen.
Step 6. Use the keys or rotary knob of the ENTRY block in one of the following ways to specify
the partial search segment number.
• Enter the desired value with the numeric keys (
[´1]
• Turn the rotary knob (
• Press the step keys ([­][¯]) to set the desired value.
NOTE
There is no key to turn on or off the partial search range in list sweep. Use the partial search
function for the segment number specified by selecting the
Press the
to
RNG LINE ON off
sweep. When the measurement parameter is COMPLEX Z-Y, however, the boundary line
is not displayed.
Chapter 8
key to display the Search menu.
[Search]
key to display the Search Range menu.
SEARCH RANGE MENU
key if the partial search range was specified as one specific
SEGMENT NUMBER
.
m m m m ) until the desired value is set.
key located in the Search Range menu to change the soft label
RNG LINE on OFF
. This will display the partial search range boundary line in the list
Analysis and Processing of Result
Specify partial search range
Key operation
[A]
[B]
Key operation
FULL
SEGMENT
to ) and then press the unit key
[0] [9]
key.
SEGMENT
269