Selecting the Phase Unit
When you are performing phase-based measurement, you can specify whether to use
degrees or radian as the phase unit applied to the scaling and marker features.
Step 1. Activate the trace for which you want to set the phase unit.
To activate:
Trace A
Trace B
NOTE
To set the phase unit, your parameter must be either |Z|-q / |Y|-q or COMPLEX Z-Y. You
should activate Trace B in the former case, and the trace whose axis format is polar in the
latter case.
Step 2. Press the
Step 3. Press the
your selection).
Softkey Labels
PHASE UNIT [DEG]
PHASE UNIT [RAD]
Chapter 7
Setting Up the Display of Measurement Results
key to display the Format menu.
[Format]
key to select your desired phase unit (pressing the key toggles
PHASE UNIT [ ]
Selecting the Phase Unit
Press:
[A]
[B]
Phase unit
Degrees (°)
Radian
197