Setting and Using the Control and Management Functions
Setting the GPIB
Setting the GPIB
This section describes how to set the interface necessary to use the GPIB (General Purpose
Interface Bus) of the E5070B/E5071B. For information on the concept and concrete
implementation of the auto measurement using GPIB, refer to "Programmers Guide."
Setting talker/listener GPIB address of E5070B/E5071B
When controlling the E5070B/E5071B using GPIB commands from the external controller
connected to the GPIB connector, you need to set the talker/listener GPIB address of the
E5070B/E5071B.
Follow these steps to make this setting:
Step 1. Press
Step 2. Press
Step 3. Press
Step 4. Press
Step 5. Enter the address using the ENTRY block keys on the front panel.
Setting system controller (USB/GPIB interface)
When controlling an external device from the E5070B/E5071B, connect the USB port of
the E5070B/E5071B and the GPIB port of the external device through the USB/GPIB
interface.
Follow these steps to set the USB/GPIB interface:
Step 1. Connect the USB port of the E5070B/E5071B to the USB/GPIB interface. The USB/GPIB
Interface Detected dialog box (Figure 13-1) appears.
NOTE
Do not connect two or more USB/GPIB interfaces.
Figure 13-1
USB/GPIB Interface Detected dialog box
426
.
.
Misc Setup
.
GPIB Setup
.
Talker/Listener Address
Chapter 13