Table of Contents
Advertisement
5
Command Reference
CALCulate Subsystem
Limit Line Subsection
56
This subsystem is used to perform post- acquisition data
processing. In effect, the collection of new data triggers the
CALCulate subsystem. In this instrument, the primary
functions in this subsystem are markers and limits.
CALCulate subsystem commands used for measurements in
the MEAS menus are located in
page 81.
Limit lines can be defined for your measurement. You can
then have the instrument compare the data to your defined
limits and indicate a pass/fail condition.
Please refer to TRACe subsystem for more trace commands.
Type of Limit Line
:CALCulate:LLINe[1]:TYPE UPPer|LOWer
:CALCulate:LLINe[1]:TYPE?
Sets a limit line to be either an upper or lower type limit
line. An upper line will be used as the maximum allowable
value when comparing with the data.
*RST:
Upper
Key access:
LIMIT > Limit Type
Turn on/off the Buzzer
:CALCulate:LLINe[1]:BUZZer[:STATe]OFF|ON|0|1
:CALCulate:LLINe[1]:BUZZer[:STATe]?
Toggles the buzzer between on and off.
If the buzzer is turned on, the buzzer will beep when the
trace doesn't meet the limit line critera.
*RST:
Off
Key access:
LIMIT > Beep On Off
"SENSe Subsystem"
N9340B Programmer's Guide
on
Advertisement
Table of Contents
