Performing Sweep Averaging
Step 1. Click
Step 2. Click the
Figure 3-69
Step 2, 3, 4
Step 3. Set the averaging count in the
Step 4. Verify that the display of the status bar on the bottom of the screen changes to "SAvg x,"
which indicates that the sweep averaging is performed x times (Figure 3-69).
NOTE
If a smooth trace cannot be obtained by performing averaging, perform the measurement
after setting the point averaging count to larger values and then performing
calibration/fixture compensation at the user-defined frequency/user-defined power points
(Figure 3-70).
Figure 3-70
(2) Frequency Characteristics of |Z|-R-X
Chapter 3
STEP 8. Measuring DUT and Analyzing Measurement Results
on the
Meas/Format...
Meas/Format
button to change the button's display to
Sweep Average
Swp Avg Count
Basic Operations for RF Devices Measurement
menu (Figure 3-8).
[On]
box (Figure 3-69).
(Figure 3-69).
89