Automatically Executing A Search Each Time A Sweep Is Done (Search Tracking) - Agilent Technologies ENA Series User Manual

Data Analysis
Searching for Positions that Match Specified Criteria
Procedure to Set Search Range
Step 1. Press
search range.
Step 2. If the trace coupling within the search range is off, press
activate the trace for which you want to set the search range.
Step 3. Press
Step 4. Press
Search Range
Step 5. Press
Search Range
Step 6. Press .
Start
Step 7. Enter the start value (lower limit) of the search range using the ENTRY block keys on the
front panel.
Step 8. Press .
Stop
Step 9. Enter the stop value (upper limit) of the search range using the ENTRY block keys on the
front panel.
Automatically executing a search each time a sweep is done (search
tracking)
Search tracking is a function that sets a search to be repeated every time a sweep is done
even if the execution key for the search (maximum, minimum, peak, and target) is not
pressed. This function facilitates observation of measurement results such as the maximum
value of traces (e.g., the insertion loss of a band pass filter).
Performing Search Tracking
Step 1. Press
which you want to set up search tracking.
Step 2. Press
Step 3. Press and turn the search tracking function on or off.
Tracking
264
or to activate the channel for which you want to set the
.
.
to turn on the Partial Search feature.
(or ) and
.
or
(or ) to activate the trace on
to
Chapter 6