Orienting The Multifeeder Pick-Up Roller; Positioning The Multifeeder Assembly Paper Guide Plate Cam - Canon NP6621 Service Handbook

STANDARDS AND ADJUSTMENTS
10 Orienting the Multifeeder Pick-
Up Roller
When installing the multifeeder pick-up roller
make sure that the side with a cross
is toward the rear.
Figure 2-216
11 Positioning the Multifeeder As-
sembly Paper Guide Plate Cam
Temporarily fix the screw with a hex nut of the
spring clutch assembly in place, and rotate the
control ring. At this time, i.e., while the claw of the
control ring is engaged with the solenoid plate,
make adjustments so that the hole (or black dot) in
the cam and the hole in the multifeeder drive unit
match; then, tighten the part in place.
Holes (or hole and black dot) matched
Gear
Control ring
Solenoid plate
Gear
Paper guide plate cam
Figure 2-217
2–6
on its collar
w
q
(front)
Horizontal line
Screw w/hex nut
Claw
Caution:
If the adjusting hole is not furnished with a black
dot for reference, make adjustments as
,
instructed while making sure that the paper
guide plate cam of the multifeeder assembly is
located as shown.
Paper guide
plate cam
130.5±0.5mm
Hole
Figure 2-218