Configuring 1-Port Adsl/Shdsl Wan Interface Card; Configuration Tasks; Configuring The Adsl/Shdsl Port On The Adsl And Shdsl Wan Interface Card - Cisco 2431 - IAD Router Software Configuration Manual

Configuring 1-Port ADSL/SHDSL WAN Interface Card

Router#

Configuring 1-Port ADSL/SHDSL WAN Interface Card

The ADSL/SHDSL WAN interface card is a 1-port WAN interface card (WIC) for the Cisco IAD2430
Series IADs. The card provides asymmetric digital subscriber line (ADSL) or symmetric high bit-rate
digital subscriber line (SHDSL) high-speed digital data transfer between a single customer premises
equipment (CPE) subscriber and the central office.
The Cisco IAD2435 router is a fixed-configuration router and does not support interface cards.
Note
ADSL/SHDSL is a last-mile access technology, which has an asymmetrical data rate running over a
Note
single copper wire pair.
A 1-port ADSL/SHDSL WIC must be installed in the router to match the DSL service to be configured.
Note

Configuration Tasks

See the following sections for configuration tasks for this feature. Each task in the list is identified as
either required or optional:
•
•
Features used on the ADSL/SHDSL WAN interface card must also be configured on the digital
subscriber line access multiplexer (DSLAM). See the documentation for the specific DSLAM for
information about configuring features.

Configuring the ADSL/SHDSL Port on the ADSL and SHDSL WAN Interface Card

Perform the following steps to configure an ADSL/SHDSL port on the ADSL/SHDSL WAN interface
card.
SUMMARY STEPS
1.
2.
3.
4.
5.
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
3-32
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
Configuring the ADSL/SHDSL Port on the ADSL and SHDSL WAN Interface Card
Verifying ATM Configuration
enable
configure terminal
interface atm slot/port
ip address ip address subnet mask
pvc name vpi/vci
Chapter 3
(optional)
Configuring with the Command-Line Interface
(required)
OL-4306-03