Prerequisites; Configuration Tasks - Cisco Octal-Port DMT ATU-C Line Card Information Manual

Prerequisites

Prerequisites
To use the 8xDMT feature, you must have one of the following DSLAMs with the 8xDMT line card, and
IOS 12.1(6) or above installed:
•
•
•

Configuration Tasks

See the following sections for configuration tasks for the 8xDMT feature. Each task in the list indicates
if the task is optional or required.
•
•
•
Preprovisioning the 8xDMT Line Card
Starting at the global configuration prompt, use the following commands to preprovision a slot for use
with the 8xDMT line card:
Command
Step 1
DSLAM(config)# slot 1 ATUC-1-DMT8
Step 2
DSLAM(config)# dsl-profile 8xDMT
Step 3
DSLAM(config-dsl-prof)# exit
Step 4
DSLAM(config)# interface atm1/1
Step 5
DSLAM(config-if)# dsl profile 8xDMT
Step 6
DSLAM(config-if)# exit
After you have completed these steps, insert the 8xDMT line card to activate the card with your
Tips
preprovisioned configuration.
Verifying the Preprovisioned Slot
Use the show running-configuration command to verify that you preprovisioned the slot correctly.
Cisco IOS Release 12.1(6)DA
6
Cisco 6015
Cisco 6160
Cisco 6260
Preprovisioning the 8xDMT Line Card, page 6
Creating and Associating a DSL Profile with Each Port, page 7
Modifying the DSL Profile, page 7
(optional)
(optional)
Purpose
This command associates the 8xDMT line card with
the specified slot.
Creates and names the DSL profile, 8xDMT in
this example.
Return to the global configuration prompt.
Enter interface configuration mode on the port
where you will associate the 8xDMT DSL profile.
Repeat this process on each port that you wish to
associate with a DSL profile.
Associates the DSL profile named 8xDMT with
atm interface 1/1.
Return to the global configuration prompt.
Octal-Port DMT ATU-C Line Card
(required)