BRP Can-Am Outlander 2015 Series Manual page 88

STORAGE PROCEDURE
SERVICE PRODUCTS
Description
BRP HEAVY DUTY CLEANER .......................................................
XPS FUEL STABILIZER..................................................................
XPS LUBE......................................................................................
XPS MULTI-PURPOSE CLEANER .................................................
XPS STORAGE OIL (EXCEPT U.S. COUNTRY) .............................
XPS STORAGE OIL (U.S. COUNTRY ONLY) .................................
GENERAL
If the ATV is not used or is to be stored for an
extended period of time, more than 4 months, be
sure to perform the storage procedures described
below.
Where applicable, refer to the appropriate sub-
sections in this manual for details of the required
tasks as outlined in these procedures.
PROCEDURES
NOTE: To facilitate the inspection and ensure
adequate lubrication of components, it is rec-
ommended to clean the entire vehicle. Refer to
VEHICLE CLEANING
in this subsection.
FUEL SYSTEM
Fuel System Protection
Pour fuel stabilizer in fuel tank and fill up fuel tank.
Start vehicle to allow for fuel stabilizer to spread
through the fuel system.
Follow the manufacturer's instructions for proper
use.
RECOMMENDED FUEL SYSTEM PROTECTION
XPS FUEL STABILIZER (P/N 413 408 601)
NOTICE
Fuel stabilizer should be added
prior to engine lubrication to ensure fuel sys-
tem components protection against varnish
deposits.
ENGINE
Engine Internal Lubrication
Engine internal parts must be lubricated to protect
them from rust formation during the storage pe-
riod.
vmr2012-006
Subsection XX (STORAGE PROCEDURE)
Part Number
293 110 001 ............................................. 3
413 408 601 ............................................. 1
293 600 016 ......................................... 1, 3
219 701 709 ............................................. 3
413 711 600 ............................................. 1
413 711 900 ............................................. 1
Proceed as follows:
1. Remove side body panels.
2. Remove spark plugs.
3. Spray storage oil into each cylinder (see follow-
ing table).
NOTE: Use the storage oil as per country availabil-
ity.
RECOMMENDED PRODUCTS
XPS STORAGE OIL (EXCEPT U.S. COUNTRY)
(P/N 413 711 600)
XPS STORAGE OIL (U.S. COUNTRY ONLY)
(P/N 413 711 900)
4. Press start button, 1 or 2 seconds maximum, to
lubricate cylinders.
5. Reinstall spark plugs.
NOTE: Do not run engine during storage period.
Engine Air Intake System
Remove parts required for access to engine air in-
let hose, refer to AIR INTAKE SYSTEM
tion.
Block engine air inlet hose using a rag to prevent
intrusion of small animals.
CVT Protection
1. Remove drive belt. Refer to
VAIABLE TRANSMISSION (CVT)
2. Inspect and clean pulleys.
3. Protect pulleys by spraying
on pulley faces.
600 016)
NOTE: Do not reinstall drive belt.
4. Close CVT cover.
5. Remove CVT outlet from exhaust system heat
shield and from CVT outlet hose.
Page
subsec-
CONTINUOUSLY
.
XPS LUBE (P/N 293
1