BRP Can-Am Outlander 2015 Series Manual page 335

Subsection XX (GEARBOX AND 4X4 COUPLING UNIT (1000))
Tmr2011-016-035_a
1. Set screw
2. Coupling fork shaft
3. Coupling fork
Countershaft
Use a soft hammer to push out countershaft from
gearbox CVT side.
Remove distance sleeve and O-ring.
Tmr2011-016-042_a
1. Countershaft
2. Distance sleeve
3. O-ring
Gearbox Bearings
If necessary heat housing up to 100°C (212°F) be-
fore removing ball bearings.
WARNING
Clean oil, outside and inside, from housing
before heating.
NOTICE
Always support gearbox housings
properly when ball bearings are removed.
Housing damages may occur if this procedure
is not performed correctly.
18
To remove ball bearings of countershaft (right
cover) and main shaft (left cover) use following
tool.
REQUIRED TOOL
BLIND HOLE BEARING
PULLER SET (P/N 529 036 117)
Remove screw securing the countershaft bearing
in the left cover.
For ball bearings of countershaft (left cover) and
main shaft (center housing) push with a suitable
puller from outside in.
Tmr2011-016-052_a
1. Ball bearing countershaft
2. Right cover
Tmr2011-016-053_a
1. Screw
2. Ball bearing countershaft
3. Ball bearing main shaft
4. Left cover
vmr2012-020