BRP Can-Am Outlander 2015 Series Manual page 647

Subsection XX (AIR CONTROLLED SUSPENSION (ACS))
vmr2013-043-024_a
1. Retaining screws
5. Unscrew air fittings and check valve.
vmr2013-043-017_d
1. Manifold air inlet fitting (from manifold)
2. Manifold inlet check valve
3. Shocks fitting
4. Module fitting
ACS Solenoid Valve Installation
The installation procedure is the reverse of re-
moval procedure, however pay attention to the
following.
If fitting is the one previously removed (old one),
apply
LOCTITE 592 (PIPE SEALANT) (P/N 293 800 018)
on all male fittings.
If fitting is a new one, do not apply sealant, it
should be already applied on male threads.
On check valve apply
LOCTITE 592 (PIPE SEALANT)
on male threads.
(P/N 293 800 018)
Install air fittings and check valve as follows with
arrows pointing toward solenoid.
10
vmr2013-043-017_c
Install air fittings and check valve as follows.
vmr2013-043-017_d
RETAINING SCREWS ARE OFFSET TOWARD MODULE FITTING
1. Manifold air inlet fitting (from manifold)
2. Auxiliary line check valve
3. Shocks fitting
4. Module fitting
Ensure that air hoses are properly inserted into fit-
tings, refer to the following illustrations.
vmo2010-011-102_a
TYPICAL - PUSH HOSE UNTIL THE MARK IS COMPLETELY
INSERTED
1. Fitting
2. Mark
A. Must be inserted into fitting
vmo2010-011-103
TYPICAL - HOSE PROPERLY INSERTED INTO FITTING
vmr2013-043