BRP Can-Am Outlander 2015 Series Manual page 587

vmr2008-068-009
TYPICAL — REAR OF WHEEL
12. Calculate the difference between the front
and rear measurements and compare with
following specifications.
SPECIFICATION
0 mm to 3 mm (0 in to .118 in) toe-in
13. If the wheel toe measurement is out of spec-
ification, carry out the following:
13.1 Loosen tie-rod end lock nuts.
13.2 Adjust tie-rod length.
NOTE: For a toe-in adjustment, the dis-
tance must be longer at the front of the
wheel. Lengthen tie-rod to increase toe-in,
and vise-versa.
The maximum
length must not exceed 32 mm (1.26 in)
Tie rod unengaged length must be the
same at both ends of the tie-rod.
tmr2011-034-107_a
TYPICAL
A. Maximum tie-rod end length
13.3 Tighten tie-rod end lock nuts to specifica-
tion.
TIGHTENING TORQUE
Tie-rod end
locking nut
14. Repeat procedure for other front wheel.
vmr2013-061
WARNING
unengaged tie-rod
34 N•m ± 2 N•m
(25 lbf•ft ± 1 lbf•ft)
Subsection 02 (STEERING SYSTEM)
PROCEDURES
HANDLEBAR GRIP
Handlebar Grip Removal
1. Loosen the screw at the end of handlebar grip.
2. Remove the handlebar grip cap.
3. Cut and remove the handlebar grip.
Handlebar Grip Installation
1. Remove all rubber residues of the old grip be-
fore installing the new.
2. Clean the handlebar with
CLEANER (P/N 413 711 809)
any greasy matter on it.
3. Install handlebar grip by blowing compressed
air between handle grip and handlebar.
4. Install a
SMOOTHFLOW™
(P/N 16 GA #511 RTT-B)
bottle of
LOCTITE 406 (GLUE) (P/N 293 800 100)
5. Lift a part of the grip using a small screwdriver
and inject glue (about 4 spots per side).
NOTE: The glue dries quickly. Do not apply it be-
fore installing grip.
6. Apply pressure on the grip for approximately
30 seconds to set the glue.
7. Install the handlebar grip cap and torque screw
0.4 N•m (3.5 lbf•in).
HANDLEBAR COVER
Handlebar Cover Removal
650 Model
Pull on plastic handlebar cover to remove it from
the handlebar.
1000 Model
Undo Velcro.
Handlebar Cover Inspection
Check covers for cracks or other damages. Re-
place if necessary.
Handlebar Cover Installation
The installation is the reverse of removal proce-
dure.
PULLEY FLANGE
or alcohol to remove
TAPERED TIP
from EFD Inc on a
.
5