BRP Can-Am Outlander 2015 Series Manual page 194

Subsection XX (TOP END)
CYLINDER HEAD SCREW IDENTIFICATION
Location no.
1
500/650/800R
engines
Location no.
2
Location no.
1
1000
engine
Location no.
2
Tighten M10 cylinder head screws FIRST as per
following specifications.
tmr2011-013-011_c
TIGHTENING SEQUENCE - M10 CYLINDER HEAD SCREWS
M10 CYLINDER HEAD SCREWS
Tightening
Torque (step
1)
M10 CYLINDER HEAD SCREWS
Tightening
Torque (step
2)
Tighten M6 cylinder head screws as per following
specification.
tmr2011-013-011_d
1. M6 Screws
14
M10 x 140
M6 x 85
M10 x 159
M6 x 105
20 N•m ± 1 N•m
(15 lbf•ft ± 1 lbf•ft)
180° +/- 5°
M6 CYLINDER HEAD SCREWS
Tightening Torque
Check timing chain guide (tensioner side) for
movement.
VALVE SPRINGS
Valve Spring Removal
Refer to following procedures in this subsection
to remove:
CAMSHAFT
–
CYLINDER HEAD
– .
Remove valve spring.
REQUIRED TOOL
VALVE SPRING COMPRESSOR
(P/N 529 035 724)
VALVE SPRING COMPRESSOR
CUP (P/N 529 035 764)
WARNING
Always wear safety glasses when disassem-
bling valve springs. Be careful when unlock-
ing valves. Components could fly away be-
cause of the strong spring preload.
R400motr79A
LOCATE VALVE SPRING COMPRESSOR CLAMP IN CENTER OF
THE VALVE
Remove valve cotters.
10 N•m ± 1 N•m
(89 lbf•in ± 9 lbf•in)
vmr2013-016