Safety Notice - BRP Can-Am Outlander 2015 Series Manual

SAFETY NOTICE

This manual supplement has been prepared as
a guide to correctly service and repair the 2013
Can-Am ™ Outlander X mr ATV as described in the
INTRODUCTION
model list in the
This edition was primarily published to be used
by mechanics and technicians who are already
familiar with all service procedures relating to
BRP products. Technicians should attend training
courses given by BRPTI.
Please note that the instructions in this manual
will apply only if proper hand tools and special ser-
vice tools are used.
The contents of this manual depicts parts and
procedures applicable to the particular product at
the time of writing. Service and warranty bulletins
may be published to update the content of this
manual. Dealer modifications that were carried
out after manufacturing of the product, whether
or not authorized by BRP, are not included.
In addition, the sole purpose of the illustrations
throughout the manual, is to assist identification
of the general configuration of the parts. They are
not to be interpreted as technical drawings or ex-
act replicas of the parts.
The use of BRP parts is most strongly recom-
mended when considering replacement of any
component. Dealer and/or distributor assistance
should be sought in case of doubt.
The engines and the corresponding components
identified in this document should not be utilized
on product(s) other than those mentioned in this
document.
It is understood that certain modifications may
render use of the ATV illegal under existing fed-
eral, provincial and state regulations.
This manual emphasizes particular information de-
noted by the following wording and symbols:
WARNING
Indicates a potential hazard that, if not
avoided, could result in serious injury or
death.
CAUTION Indicates a hazardous situation
which, if not avoided, could result in minor or
moderate injury.
NOTICE
Indicates an instruction which, if not
followed, could result in severe damage to ve-
hicle components or other property.
vmr2013-054
NOTE: Indicates supplementary information re-
quired to fully complete an instruction.
Although the mere reading of such information
.
does not eliminate the hazard, your understanding
of the information will promote its correct use.
Always observe common shop safety practice.
Unless otherwise noted, the engine must be
stopped and the key must be removed prior to
performing any services.
Torque wrench tightening specifications must be
strictly adhered to. Use the torque values and ser-
vice products as in the exploded views or in the
procedures when noted.
Locking devices when removed must be replaced
(e.g.: locking tabs, elastic stop nuts, self-locking
fasteners, cotter pins, etc.).
Hoses, cables and locking ties removed during a
procedure must be reinstalled as per factory stan-
dards.
When ordering parts always refer to the specific
model
We strongly recommend that any services be car-
ried out and/or verified by a highly skilled profes-
sional mechanic.
It is understood that this manual may be trans-
lated into another language. In the event of any
discrepancy, the English version shall prevail.
BRP disclaims liability for all damages and/or in-
juries resulting from the improper use of the con-
tents of this publication.
SAFETY NOTICE
PARTS CATALOGS .
V