BRP Can-Am Outlander 2015 Series Manual page 166

Subsection 05 (COOLING SYSTEM)
mmr2009-112-028_a
WATER PUMP SHAFT ASSEMBLY
1. Surface where rotary seal is pushed by tool
NOTICE
Never use a hammer for rotary seal
installation. Only use a press to avoid damag-
ing the ceramic component.
tmr2011-011-015_a
1. Water pump shaft with rotary seal
2. Water pump seal installer
NOTICE
After installation, water pump shaft
with rotary seal must rotate freely.
20
WATER PUMP GEARS
Water Pump Gears Identification
vmr2012-013-009_a
1. Water pump shaft
2. Water pump gear
3. Water pump intermediate drive gear
4. Water pump intermediate shaft
5. Water pump drive gear (See BOTTOM END subsection)
Water Pump Gears Inspection
Water Pump Gear
Inspect water pump gear for wear and damage on
the snap mechanism to the needle pin. Replace if
damaged.
tmr2011-011-008_a
CRANKCASE MAG SIDE
1. Circlip
2. Water pump gear
Water Pump Intermediate Drive Gear
Check water pump intermediate drive gear for
wear or broken teeth. Replace if damaged.
vmr2013-058