Chassis (Wheels And Tires) - BRP Can-Am Outlander 2015 Series Manual

Hide thumbs

Table of Contents

Subsection XX (PERIODIC MAINTENANCE PROCEDURES)

tmr2011-032-006_a

LH REAR SIDE OF VEHICLE

1. Filler plug

4. Verify the oil level by inserting a wire with a 90°

bend through the oil filler hole.

5. Oil level must be within the following specifica-

tion from the bottom of oil filler hole.

20 mm ± 5 mm (9/16 in ± 3/16 in)

6. Reinstall filler plug with a NEW sealing ring.

Tightening Torque

Rear Final Drive Oil Replacement

1. Ensure vehicle is on a level surface.

2. Clean filler and drain plug areas.

3. Place a drain pan under rear final drive.

4. Unscrew filler plug.

5. Remove drain plug.

tmr2011-032-006_b

LH REAR SIDE OF VEHICLE

1. Drain plug

2. Filler plug

6. Install drain plug.

22.5 N•m ± 2.5 N•m

(17 lbf•ft ± 2 lbf•ft)

Tightening Torque

7. Refill the rear final drive.

RECOMMENDED OIL

XPS SYNTHETIC

GEAR OIL (75W 140)

(P/N 293 600 140)

or a 75W 140

(API GL-5) gear oil

8. Reinstall filler plug with a NEW sealing ring.

Tightening Torque

Drive Shaft Boot and Protector

1. Visually inspect each drive shaft boot for grease

leak, cracks or opening.

2. Check if the drive shaft boot protectors are

fixed firmly, not torn or otherwise damaged.

3. Replace if necessary.

Drive Shaft Joint Inspection

Turn and move drive shaft back and forth to detect

excessive play.

Rear Propeller Shaft U-Joint Condition

Check yoke U-joints for wear, backlash or axial

play. Replace if necessary.

Rear Propeller Shaft U-Joint

PROPELLER SHAFT U-JOINT LUBRICATION

Use Hi-temp bearing grease NLGI-2 or an equivalent