BRP Can-Am Outlander 2015 Series Manual page 739

vmr2013-045-011_a
1. Retaining nuts and bolts securing rack to frame
2. Frame
3. Rack assembly
2. Remove rack from vehicle.
3. Remove retaining screws securing rack to rail.
Rear Rack Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
TIGHTENING TORQUE
Screws and nuts
securing rear rack to rail
Screws an nuts securing
rear rack assembly
to frame
REAR STORAGE COMPARTMENT
REAR STORAGE COMPARTMENT
COVER
Rear Storage Compartment Cover
Replacement
1. Open rear storage compartment cover.
2. Push rear storage compartment cover forward
to release it from hinges.
vmr2013-045
4.5 N•m ± 0.5 N•m
(40 lbf•in ± 4 lbf•in)
4.5 N•m ± 0.5 N•m
(40 lbf•in ± 4 lbf•in)
Subsection XX (BODY (OUTLANDER))
vmr2012-043-030_a
TYPICAL
3. Install a new rear storage compartment cover
as the reverse of removal.
Rear Storage Compartment
Rear storage Compartment Removal
1. Remove rear body module. Refer to
BODY MODULE
.
2. Remove rear rack. Refer to
MOVAL
.
3. Remove rear storage compartment cover.
Refer to REAR STORAGE COMPARTMENT
COVER .
4. Remove retaining screws securing bottom of
RH rear storage compartment support.
vmr2013-045-028_a
1. Retaining screws securing bottom of RH rear storage
compartment support
5. Remove retaining screws securing RH rear
storage compartment support to RH support.
6. Remove retaining screw securing RH fender to
rear storage compartment.
REAR
REAR RACK RE-
25