BRP Can-Am Outlander 2015 Series Manual page 45

Subsection XX (PERIODIC MAINTENANCE PROCEDURES)
vmo2006-007-013_a
TYPICAL - RH SIDE OF ENGINE
1. Dipstick
With vehicle on a level surface and engine cold,
not running, check the oil level as follows:
1. Unscrew dipstick then remove it and wipe
clean.
2. Reinstall dipstick, screw in it completely.
3. Remove and check oil level. It should be near
or equal to the upper mark.
vmr2006-008-002_a
1. Full
2. Add
To add oil, remove the dipstick. Place a funnel into
the dipstick orifice.
Add a small amount of recommended oil and
recheck oil level.
Repeat the above procedures until oil level
reaches the dipstick's upper mark.
NOTE: Do not overfill. Wipe off any spillage.
Properly tighten dipstick.
Engine Oil Change
1. Start and warm-up engine.
6
2. Stop engine.
3. Ensure vehicle is on a level surface.
4. Remove dipstick.
5. Place a drain pan under the engine drain plug
area.
6. Clean the drain plug area.
7. Unscrew drain plug and discard the gasket ring.
CAUTION The engine oil can be very hot.
vmo2012-012-058_a
1. Drain plug
NOTE: Allow oil to drain completely from the
crankcase.
8. Clean the magnetic drain plug from metal shav-
ings and residue. Presence of debris gives an
indication of internal engine damage.
9. Install a NEW gasket ring on the drain plug.
NOTICE
Never use the gasket ring a second
time. Always replace by a new one.
10. Install and tighten drain plug to the recom-
mended torque.
DRAIN PLUG
Tightening Torque
11. Replace oil filter. Refer to
REPLACEMENT in this subsection.
12. Refill engine with recommended engine oil.
ENGINE OIL CAPACITY
2 L (2.1 qt (U.S. liq.))
13. After filling, check the oil level, refer to
GINE OIL LEVEL VERIFICATION
section.
14. Start engine and let it idle for a few minutes.
15. Ensure oil filter and drain plug areas are not
leaking.
30 N•m ± 2 N•m
(22 lbf•ft ± 1 lbf•ft)
ENGINE OIL FILTER
EN-
in this sub-
vmr2012-005