BRP Can-Am Outlander 2015 Series Manual page 254

Subsection XX (CONTINUOUSLY VARIABLE TRANSMISSION (CVT))
vmr2006-021-051_a
1. Drive pulley screw
2. Conical spring washer
3. Thrust washer
WARNING
Never substitute conical spring washer
and/or screw with aftermarket parts. Al-
ways use genuine BRP parts.
Lock the drive pulley as per removal procedure.
Tighten drive pulley screw to specification.
NOTICE
Never use any type of impact
wrench for drive pulley installation.
DRIVE PULLEY SCREW
Tightening Torque
tmr2013-019-006_a
1. Clutch holder (P/N 529 036 238)
2. Drive pulley
14
120 N•m ± 8 N•m
(89 lbf•ft ± 6 lbf•ft)
DRIVEN PULLEY
Driven Pulley Removal
1. Remove drive belt, refer to
MOVAL
in this subsection.
2. Hold the driven pulley and loosen the driven pul-
ley screw.
NOTE: Do not completely remove the driven pul-
ley screw.
REQUIRED TOOL
CLUTCH HOLDER
(P/N 529 036 238)
tmr2013-019-007_a
1. Driven pulley screw
2. Clutch holder (P/N 529 036 238)
3. Remove service tool.
4. Apply axial pressure with your hand on driven
pulley and maintain during screw removal.
5. Remove driven pulley screw and washer. Dis-
card driven pulley screw.
CAUTION Driven pulley is spring loaded.
Hold driven pulley tight and slowly remove the
driven pulley screw to release spring tension.
DRIVE BELT RE-
vmr2013-019