BRP Can-Am Outlander 2015 Series Manual page 113

Subsection XX (EXHAUST SYSTEM)
vmr2013-011-002_a
LH SIDE — PARTS REMOVED FOR CLARITY
1. Heat shield
2. Remove bolts
Heat Shield Installation
For the installation, reverse the removal proce-
dure.
Y-EXHAUST PIPE
Y-Exhaust Pipe Removal
1. Remove MUFFLER . See procedure in this sub-
section.
HEAT SHIELD
2. Remove
subsection.
3. Remove the following parts:
– Springs from head pipe
– Y-exhaust pipe from vehicle.
vmr2012-011-010_a
LH SIDE — PARTS REMOVED FOR CLARITY - TYPICAL
1. Y-exhaust pipe
2. Springs
Y-Exhaust Pipe Inspection
Check Y-exhaust pipe for cracks, bending or other
damages. Replace if needed.
4
. See procedure in this
Y-Exhaust Pipe Installation
The installation is the reverse of the removal pro-
cedure.
Install NEW exhaust gaskets.
Properly position exhaust pipe before tightening.
TORQUE
Head pipe nuts
(rear cylinder)
HEAD PIPE (FRONT CYLINDER)
Front Head Pipe Removal
1. Remove Y-EXHAUST PIPE
this subsection.
BODY
2. Refer to and remove rear part of RH
inner fender to reach head pipe screws (Out-
lander series only).
vmr2012-011-012_a
1. Remove
3. Remove front head pipe from vehicle.
13 N•m ± 1 N•m
(115 lbf•in ± 9 lbf•in)
See procedure in
vmr2013-011