BRP Can-Am Outlander 2015 Series Manual page 100

10. Move propeller shaft yoke downwards to
make room.
vmr2012-009-023
TYPICAL
11. Move engine rearward to disconnect front pro-
peller shaft from engine.
12. Remove engine by the RH side.
vmr2012-009-024
TYPICAL
ENGINE INSTALLATION
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
1. Inspect condition of engine mounts.
2. Install engine on vehicle.
3. Install all engine retaining bolts loosely.
4. Install and tighten propeller shaft screw. Refer
to REAR DRIVE subsection.
5. Tighten engine retaining bolts to specification.
vmr2013-009
Subsection XX (ENGINE REMOVAL AND INSTALLATION)
Engine retaining bolts
6. If applicable, fill engine as per specification. Re-
fer to
7. Fill and bleed cooling system. Refer to
ODIC MAINTENANCE PROCEDURE
tion.
8. Check for any leaks.
9. Reinstall all the remaining parts as the reverse
of removal procedure. Refer to exploded views
and proper subsections.
10. Test drive vehicle to confirm proper operation.
ENGINE MOUNTS
REPLACEMENT
NOTE: Use the same procedure for the front and
rear engine mounts.
Engine Mount Removal
Insert a punch into engine mount bushing and
push the opposite engine mount out.
tmr2011-007-011
TYPICAL
Engine Mount Installation
The installation is the reverse of the removal pro-
cedure.
TORQUE
62.5 N•m ± 7.5 N•m
(46 lbf•ft ± 6 lbf•ft)
LUBRICATION SYSTEM
subsection.
PERI-
subsec-
7