Subsection XX (BRAKES)
529036166
Brake Light Switch Replacement
Brake Light Switch Located on Brake Lever
1. Disconnect brake light switch connector.
2. Replace brake light switch by a new one.
3. Connect brake light switch connector.
Brake Light Switch Located on Master
Cylinder or Manifold
1. Disconnect brake light switch connector.
2. Drain brake line.
3. Remove brake light switch.
NOTE: Use shop rags to catch any spilled brake
fluid.
4. Install NEW sealing washers.
5. Install brake light switch.
TORQUE
Brake light switch
6. Connect brake light switch connector.
7. Refill and bleed brake system, refer to
ODIC MAINTENANCE PROCEDURES
tion.
BRAKE PEDAL
Brake Pedal Removal
1. Drain brake system, refer to
TENANCE PROCEDURES
2. Remove RH footrest panel. Refer to
subsection.
3. On Renegade models, remove engine panel.
Refer to
BODY
subsection.
NOTE: Loosen brake pedal bolt before removing
support from frame.
4. Remove master cylinder support from frame.
14
28.5 N•m ± 1.5 N•m
(21 lbf•ft ± 1 lbf•ft)
PERI-
subsec-
PERIODIC MAIN-
subsection.
BODY
vmr2012-042-001_a
TYPICAL - SOME PARTS REMOVED FOR CLARITY
1. Master cylinder support
5. Remove brake pedal spring.
vmr2012-042-002_a
1. Brake pedal spring
6. Remove brake pedal.
vmr2012-042-003_a
1. Brake pedal pivot bolt
Brake Pedal Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
vmr2013-044