BRP Can-Am Outlander 2015 Series Manual page 431

vmr2006-014-064_b
1. Contact here
2. Free-play here
CAUTION If there is no free-play at idle
position, it may cause poor idling and starta-
bility problems. Improper cable adjustment
will cause strain on cable and/or damage cable
bracket or throttle lever at handlebar.
WARNING
Make sure idle speed stopper contacts throt-
tle cam when throttle lever is fully released at
handlebar.
If adjustment is needed, proceed with adjuster at
handlebar. Adjust to have 2 mm (.078 in) free-play
at the end of throttle lever. When done, slide back
cable protector over adjuster.
vmr2006-014-067_a
1. Adjuster lock nut
2. Adjuster
Turn handlebar side to side and ensure there is still
free-play in each position.
To ensure there is no strain in the cable at wide
open position:
– Fully depress throttle lever and hold.
vmr2013-027
Subsection XX (ELECTRONIC FUEL INJECTION (EFI))
– Loosen adjuster lock nut/adjuster until it just re-
leases lever.
– Turn adjuster clockwise until it touches lever
again.
– From there, tighten adjuster 1/2 turn (to remove
strain in cable).
– Tighten lock nut.
– Release throttle lever.
vmr2006-014-068_a
1. Adjuster lock nut
2. Adjuster
Reinstall throttle cable cover.
THROTTLE BODY
Throttle Body Description
vmr2006-014-010_a
1. Throttle body
2. Throttle cable attachment
3. Throttle plate
4. TPS
5. Idle air bypass channel
6. Idle air control valve
13