BRP Can-Am Outlander 2015 Series Manual page 252

Subsection XX (CONTINUOUSLY VARIABLE TRANSMISSION (CVT))
Check for any marks on fixed sheave plate. Re-
place if necessary.
Spring
Measure spring free length and squareness. If
spring is out of specification, replace by a new
one.
CLUTCH SPRING FREE LENGTH
500 AND 650 SERVICE
ENGINE LIMIT
800R AND
SERVICE
1000 ENGINE LIMIT
CLUTCH SPRING SQUARENESS
ALL SERVICE
ENGINES
LIMIT
One-Way Clutch
Check bearings for excessive play and smooth op-
eration. Replace bearings if necessary.
NOTICE
Be careful not to damage the inside
of one-way clutch during bearing removal.
vmr2006-021-028_a
1. One-way clutch
2. Bearings
Measure length of spring sleeves and check if
edges on top of the spring sleeve are excessively
worn. If out of specification, replace both spring
sleeves at the same time.
SPRING SLEEVE LENGTH
NEW
SERVICE LIMIT
Drive Pulley Assembly
For assembly, reverse the disassembly proce-
dure. Pay attention to following details.
12
85 mm (3.346 in)
105 mm (4.134 in)
4 mm (.157 in)
9.2 mm to 9.4 mm
(.362 in to .37 in)
9 mm (.354 in)
One-Way Clutch
Clean parts.
Lubricate springs, spring sleeves and between
one way clutch bearings using recommended
product.
REQUIRED PRODUCT
ISOFLEX GREASE TOPAS NB 52 (P/N 293 550 021)
1000 Engine
NOTE: Ball bearings have a seal on one side only.
Install bearings with the seal towards the outside
of the one-way clutch.
NOTE: Apply
ISOFLEX GREASE TOPAS NB 52
inside ball bearings to ensure
(P/N 293 550 021)
adequate lubrication.
tmr2011-015-020_a
1. One-way clutch
2. Bearing
3. Retaining ring
4. Seal
Friction Washer
500/650/800R Engine Only
NOTE: Apply recommended grease on both sides
of friction washer.
REQUIRED PRODUCT
ISOFLEX GREASE TOPAS NB 52 (P/N 293 550 021)
NOTE: Friction washer must be assembled with
collar towards one way clutch.
vmr2013-019