BRP Can-Am Outlander 2015 Series Manual page 69

Subsection 03 (PERIODIC MAINTENANCE PROCEDURES)
Engine Oil Change
1. Start and warm-up engine.
2. Stop engine.
3. Ensure vehicle is on a level surface.
4. Remove dipstick.
5. Place a drain pan under the engine drain plug
area.
6. Clean the drain plug area.
7. Unscrew drain plug and discard the gasket ring.
CAUTION The engine oil can be very hot.
vmo2012-012-058_a
1. Drain plug
NOTE: Allow oil to drain completely from the
crankcase.
8. Clean the magnetic drain plug from metal shav-
ings and residue. Presence of debris gives an
indication of internal engine damage.
9. Install a NEW gasket ring on the drain plug.
NOTICE
Never use the gasket ring a second
time. Always replace by a new one.
10. Install and tighten drain plug to the recom-
mended torque.
DRAIN PLUG
Tightening torque
11. Replace oil filter. Refer to
REPLACEMENT
in this subsection.
12. Refill engine with recommended engine oil.
ENGINE OIL CAPACITY
2 L (2.1 qt (U.S. liq.))
13. After filling, check the oil level, refer to
GINE OIL LEVEL VERIFICATION
section.
14. Start engine and let it idle for a few minutes.
6
30 N•m ± 2 N•m
(22 lbf•ft ± 1 lbf•ft)
ENGINE OIL FILTER
EN-
in this sub-
15. Ensure oil filter and drain plug areas are not
leaking.
16. Stop engine.
17. Wait a while to allow oil to flow down to
crankcase, then check oil level again.
18. Dispose oil and filter as per your local environ-
mental regulations.
Engine Oil Filter Replacement
Engine Oil Filter Access
To reach oil filter, refer to
following parts (Outlander models):
– Seat
– Console
– RH side panel
– RH footrest panel.
Engine Oil Filter Removal
1. Clean oil filter area.
2. Remove oil filter cover screws.
3. Remove oil filter cover.
4. Remove oil filter.
tmr2011-010-004_a
1. Oil filter screw
2. Oil filter cover
3. O-ring
4. Oil filter
Engine Oil Filter Installation
1. Check and clean the oil filter inlet and outlet
area of dirt and other contaminations.
BODY
and remove the
vmr2013-056