BRP Can-Am Outlander 2015 Series Manual page 294

Subsection XX (GEARBOX AND 4X4 COUPLING UNIT (500/650/800R))
– Console
– RH side panel
– RH footrest panel
– Shift plate from shift shaft (refer to
Using a suitable tube with the proper diameter to
install the shift shaft oil seal.
If gearbox housing is apart, the following tools can
be used for shift shaft oil seal installation.
REQUIRED TOOL
OIL SEAL INSTALLER
(GEARBOX) (P/N 529 035 758)
HANDLE (P/N 420 877 650)
NOTICE
Oil seal must be installed with seal-
ing lip toward gearbox.
Output Shaft Oil Seal
Remove propeller shaft. Refer to
subsection.
Punch a sharp screwdriver through oil seal for re-
moval.
NOTE: When oil seal is removed also inspect
O-ring.
vmr2012-019-008_a
1. Distance sleeve
2. O-ring
8
SHIFTER .
vmr2006-022-007_a
1. Shift shaft oil seal
2. Output shaft oil seal
For output shaft oil seal installation use the follow-
ing service tool.
REAR DRIVE
DRIVE SHAFT OIL SEAL
INSTALLER (P/N 529 036 028)
vmr2006-022-008_a
1. Output shaft oil seal
2. Oil seal installer
ACTUATOR
Actuator Access
To access the actuator, refer to
the following parts:
– Seat
– Console
– RH side panel
– RH footrest panel
– RH engine panel (Renegade only).
REQUIRED TOOL
BODY and remove
vmr2012-019