BRP Can-Am Outlander 2015 Series Manual page 249

Drive Pulley Cleaning
Clean pulley faces and shaft with fine steel wool
and a dry cloth.
Using a paper towel with the recommended
cleaning solvent, clean:
– Crankshaft tapered end
– Taper inside the fixed sheave of the drive pulley
– Crankshaft threads
– Drive pulley screw threads.
REQUIRED PRODUCT
PULLEY FLANGE CLEANER (P/N 413 711 809)
NOTICE
Avoid contact between cleaner and
crankshaft seal as damage may occur.
Remove all hardened oil deposits that have baked
on the crankshaft and pulley tapered surfaces us-
ing coarse or medium steel wool, and/or sand pa-
per no. 600.
NOTICE
Do not use any other type of abra-
sive.
Reclean mounting surfaces with paper towel and
PULLEY FLANGE CLEANER (P/N 413 711 809)
Wipe off the mounting surfaces with a clean, dry
paper towel.
NOTICE
Mounting surfaces must be free of
any oil, cleaner or towel residue.
vmr2006-021-022_a
1. Taper of fixed sheave
Only use petrol base cleaner when cleaning slid-
ing sheave bushings.
vmr2013-019
Subsection XX (CONTINUOUSLY VARIABLE TRANSMISSION (CVT))
.
NOTICE
Do not use acetone to clean bush-
ing.
tmr2011-015-006_a
1. Sliding sheave
2. Bushings
Drive Pulley Inspection
Bushings
For bushing inspection, refer to
in this subsection.
Governor Cup
Check governor cup for cracks or other visible
damage. Replace if necessary.
Roller and Slider Shoe
Check each roller for roundness of external diam-
eter.
Check if rollers move freely.
NOTICE
Whenever replacing rollers and
slider shoes, always replace all rollers and
slider shoes as a set.
Check slider shoes for visible wear and replace if
damaged.
NOTE: If necessary, use a screwdriver to remove
slider shoes.
SLIDING SHEAVE
9