BRP Can-Am Outlander 2015 Series Manual page 438

Subsection XX (ELECTRONIC FUEL INJECTION (EFI))
529036166
Using a multimeter, measure resistance as per ta-
ble.
ECM ADAPTER
PIN
D1 E1
If resistance value is incorrect, check or repair the
connectors and the wiring harness between ECM
connector and the CPS. If resistance value is still
incorrect, replace CPS.
CPS Replacement
CPS ACCESS
Refer to in this subsection to reach
CPS.
Disconnect CPS connector and cut harness lock-
ing tie (if applicable).
Remove CPS retaining screw and pull up on CPS
to remove it.
vmr2006-014-004_a
TYPICAL
1. CPS
2. Retaining screw
Install new CPS and secure harness with a new
locking tie (as applicable).
20
MEASUREMENT
RESISTANCE
@ 20°C (68°F)
700 - 900
CPS INSTALLATION
O-RING
XPS SYNTHETIC GREASE
TIGHTENING TORQUE
SENSOR
SCREW
MANIFOLD ABSOLUTE
PRESSURE AND TEMPERATURE
SENSOR (MAPTS)
vmr2006-012-004_d
1. Manifold absolute pressure and temperature sensor (MAPTS)
NOTE: This sensor is a multifunction device.
MAPTS Access
Remove the RH side panel. Refer to
section.
MAPTS Pressure Function
Before the engine is started, when power is ap-
plied to the system, the sensor measures the
ambient air atmospheric pressure. The ambient
pressure is, at that moment, stored in the ECM.
Thereafter, once the engine is started, it mea-
sures the air pressure in the intake manifold at
operating RPMs.
The sensor must be correctly installed on intake
manifold. Otherwise, the MAPTS could generate
a fault code for an unexpected sensor range at idle
when it reads the atmospheric pressure. If this
PRODUCT
(P/N 293 550 010)
10 N•m ± 1 N•m
(89 lbf•in ± 9 lbf•in)
BODY
sub-
vmr2013-027